JB Systems COB-4BAR Operation Manual page 8

ENGLISH
 Press the ENTER button to confirm.
IMPORTANT: If you want to use the automatic modes and make the settings directly on the bar, you
need to deactivate the IR remote control receiver in the bar. (IR ACTIVE = OFF)
SOUND MODE
Used to set the parameters for the automatic Sound Mode.
 Press the MODE button until SOUND MODE is shown on the display.
 Press the ENTER button to enter the configuration mode
 The value of the sensitivity (SENS) will start blinking on the display
 Use DOWN and UP buttons to change the sensitivity of the build-in microphone (00 = minimal sensitivity,
31 = maximal sensitivity).
 Press the ENTER button to confirm.
 The value of the frequency (FQN) will start blinking on the display
 Use DOWN and UP buttons to change the number of times each automatic program should be repeated
before to go automatically to the next automatic program.
 Press the ENTER button to confirm.
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
STATIC COLOR MODE:
Used to set a static color for the projectors.
 Press the MODE button until 01.STATIC or xx.EFFECT (number 02 to 14 followed by EFFECT) is shown
on the display.
 Press the ENTER button to enter the configuration mode
 The actual mode (static or effect mode) is blinking on the display
 If necessary, use the DOWN and UP buttons to select 01.STATIC
 Press the ENTER button to enter the configuration mode for the static colors
 Use DOWN and UP buttons to select COLOR_CW (cold white), COLOR_WW (warm white) or COLOR
SET (to compose your own color).
 If you have chosen COLOR_CW or COLOR_WW : just press the ENTER button to confirm your choice
 If you have chosen COLOR SET: press the ENTER button to access the manual color settings
 RED is blinking on the display: use the DOWN and UP buttons to set the intensity of the red color
(000 = minimum, 255 = maximum)
 Press the ENTER button to confirm and to go to the next color
 GREEN is blinking on the display: use the DOWN and UP buttons to set the intensity of the green
color (000 = minimum, 255 = maximum)
 Press the ENTER button to confirm and to go to the next color
 BLUE is blinking on the display: use the DOWN and UP buttons to set the intensity of the blue
color (000 = minimum, 255 = maximum)
 Press the ENTER button to confirm
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
SLOW COLOR FADE MODE:
Used to let the projectors slowly fade from one color into another.
 Press the MODE button until 01.STATIC or xx.EFFECT (number 02 to 14 followed by EFFECT) is shown
on the display.
 Press the ENTER button to enter the configuration mode
 The actual mode (static or effect mode) is blinking on the display
 Use the DOWN and UP buttons to select 02.EFFECT (fading from one color into another) or
04.EFFECT (each color fading on and off)
 Press the ENTER button to confirm
 Speed starts blinking on the display: Use the DOWN and UP buttons to set the desired running speed (00
= slow, 99 = maximum speed)
 Press the ENTER button to confirm
 Flash starts blinking on the display: Use the DOWN and UP buttons to set the desired speed for the
stroboscopic effect (00 = off, 99 = maximum speed)
 Press the ENTER button to confirm
JB SYSTEMS
®
6/74
USER MANUAL
COB-4BAR