Removing The Water Inlet/Dispenser Valve Assembly, Power Supply Cord, And Machine/Motor Control & Pressure Transducer - Maytag MTW6500TB Service Manual

REMOVING THE WATER INLET/ DISPENSER VALVE
ASSEMBLY, POWER SUPPLY CORD, AND
MACHINE/MOTOR CONTROL & PRESSURE TRANSDUCER
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off water supply.
3. Remove the console from the top of the
washer (see page 4-2 for the procedure).
Power Supply Cord
Water Inlet/Dispenser Valve Assembly
4. To remove the water inlet/dispenser
valve assembly (see the top right pho-
to):
a) Disconnect the hot and cold water
hoses from the water inlets.
b) Release the locking tab and discon-
nect the wire connectors from the wa-
ter inlet/dispenser valve assembly so-
lenoid terminals.
c) Release the locking tab and discon-
nect the wire connector from the ther-
mistor.
Machine/Motor Control
Violet
White
Yellow
Water Inlet/Dispenser Valve Assembly
d) Tape the washer lid closed.
e) Using a putty knife, press and unlock the
two front top locks. The locks are approx-
imately 6-1/2˝ from the outside edge of
the washer.
Tape Lid
Lift Top
4-4
Violet
Red
Thermistor
Tape Lid
6-1/2˝
Press Top Lock
White