When Not In Use; Scheduled Maintenance - Piazzetta P963 Instructions For Installation, Use And Maintenance Manual

a
Since such a procedure involves dismantling certain parts of
the stove, have the cleaning carried out only by a Piazzetta
Service Centre or other qualified persons.
To access the room fan/s, remove the side ceramic panel/s (see
instructions in CLADDING booklet).
Remove the cover plate (A) screwed onto the external housing by
loosening the screws. (Fig. 74)
Clean the fan/s (Fig. 75) then refit the cover plate (A) and the side
ceramic panel/s.

7.12 WHEN NOT IN USE

When shutting the stove down for the summer, proceed as follows:
- remove all pellets from the hopper and feeding auger;
- carefully clean the grate, the grate support and the ash drawer;
- using a steel brush, clean the baffle plate or internal baffle plates of the firebox and coat them using a spray paint (not supplied), to prevent them
from oxidising and consequently forming rust.
a
If the cast-iron parts inside the firebox are not coated, rust could form. This is a natural process, which does not affect the efficiency
and quality of the product.
- Clean the flue thoroughly: contact a professional chimneysweep for this purpose;
- clean by removing all dust, cobwebs, etc. from the area behind the inner lining panels once a year, in particular the fans;
- disconnect the power cable from the power supply;
- remove the batteries from the remote control.

7.13 SCHEDULED MAINTENANCE

a
Scheduled maintenance must be carried out ONCE A YEAR and prior to starting up the appliance, especially after a long period of
inactivity. This maintenance is necessary to ensure the appliance remains in efficient and safe working order.
a
The appliance must be DISCONNECTED FROM THE POWER SUPPLY for all cleaning and maintenance work.
a
Since the following maintenance necessitates removing some parts of the appliance, it is advisable to have the scheduled maintenance
carried out by an After-Sales Service Centre or a qualified person.
- Clean the grate (see "CLEANING THE GRATE").
- Clean the firebox (see "CLEANING THE FIREBOX").
- Clean the flue system (see "CLEANING THE FLUE SYSTEM").
- Clean the painted metal parts (see "CLEANING THE PAINTED METAL PARTS").
- Clean the glass (see "CLEANING THE GLASS").
- Clean the fans (see "CLEANING THE FANS").
- Clean away dust and cobwebs from the gap between the appliance and the cladding.
- Check the electrical part and the electronic components.
- Check the tightness and state of the gaskets/seals of the glass door and of all the elements subject to wear and if necessary replace.
- Carry out all maintenance and checks required for correct operation and compliance with safety regulations and standards.
- Light the appliance in accordance with instructions given under "LIGHTING FOR THE FIRST TIME".
64
Fig. 75
H07032120 / DT2002308 – 00
DT2010096-04
DT2012636-00