Piazzetta P963 Instructions For Installation, Use And Maintenance Manual page 34

C L E A N I N G
Action
B R A Z I E R
Shut the stove down
.
1 2 : 0 0 2 2 c
by pressing the
• The warning buzzer stops.
ON/OFF key down for
• The readout CLEANING GRATE appears on the display and when the
1
a few seconds
• Check the cause of failed ignition and why the safety device has
C L E A N I N G
B R A Z I E R
.
1 2 : 0 0 2 2 c
Restart the stove by
pressing the ON/OFF
1
key
• Repeat the ignition process as described above.
a
If the stove occasionally fails to ignite it could be caused by:
- pellet composition or size not in compliance with the specifications given in this booklet (see the "FUEL" section);
- insufficient mains voltage, whether in the form of intermittent voltage drops or a constantly lower value.
In the above cases any call-out of the service centre is not covered by the warranty, since the problem is not due to a defect in the
product.
Action
The user attempts
W A I T F O R
to restart the stove
during the shutdown
S T A R T U P If the readout "WAIT FOR START UP" appears on the display by pressing
stage when the
the ON/OFF key for a few moments, it means that the stove is still hot and
stove is still hot by
it is necessary to wait for it to cool.
1 2 : 0 0 7 3 F
pressing the ON/
The new ignition cycle will be inhibited until the stove ends the cooling
OFF key for a few
1
phase.
moments
After waiting for a few minutes the user can restart the stove and a new
ignition cycle will start automatically from the control stage.
34
FAILED IGNITION: WHAT TO DO
Description
stove has cooled the readout OFF appears.
activated. Always remove any fuel from the grate before starting a new
ignition process.
Description
WAIT FOR START UP
H07032120 / DT2002308 – 00
Display
C L E A N I N G
G R A T E
1 2 : 0 0 7 3 F
1
DT2040057-07
Display
W A I T F O R
S T A R T U P
1 2 : 0 0 7 3 F
1
DT2040123-00