Storing Stations In Preset Memories - Sangean PR-D4 Operating Instruction

Manual tuning/station searching
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
Adjust the antenna as described above .
3. A single press on either the Tuning up or down button will change
the frequency in the following increments:
FM: 50 or 100 kHz
MW: 9 or 10 kHz
4. Press and hold either Tuning Up or Down button until the frequency
in the display begins to change rapidly. Release the button.
Your radio will search the selected waveband and stop
automatically when it finds a station of sufficient strength.
5. Rotate the Volume control to get required sound level.
6. To turn off the radio, press the Power button.
Display will show OFF.

Storing stations in preset memories

There are 5 memory presets for each waveband.
1. Press the Power button to turn on the radio.
2. Tune to required station using one of the methods
previously described.
3. Press and hold down the required preset until the radio beeps.
The preset number will appear in the display and the station will
be stored under chosen preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be overwritten by
following above procedures.
7