Setting The Clock; Operating The Radio; Scan Tuning - Sangean PR-D4 Operating Instruction

Setting the clock

1. Clock can be set either the radio is power on or off.
2. Display will show " - : - - " when the batteries are installed or when
the radio is connected to the mains supply.
3. Press the button for more than 2 seconds, display will flash time
set symbol and also the hour digits, followed by a beep.
4. Press Tuning Up/Down buttons to set the required hours.
5. Press button, the minute digits will flash.
6. Press Tuning Up/Down buttons to set required minute.
7. Press the button to complete time setting.

Operating the radio

This radio is equipped with three tuning methods – Scan tuning,
Manual tuning and Memory presets recall.

Scan tuning

1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
For FM band fully extend and rotate telescopic aerial to get
best reception. For MW (AM) band, rotate the radio to get
best signal.
3. Press and release Scan button (long press Scan button more than
2 seconds will activate time setting), the radio will up search and
stop automatically when it finds a radio station.
Press the Scan button again to pick up the found station .
Note:
The radio will continue to search next available stations if you
do not press Scan again when it finds a radio station.
4. Rotate the Volume control to get required sound level.
5. To turn off the radio, press the Power button.
Display will show OFF.
GB
6