Buzzer Alarm - Sangean PR-D4 Operating Instruction

b. Setting radio alarmed station:
1. During setting radio alarm time and radio alarm symbol
is flashing, press Band button to activate the radio to select
required wake-up band and station by manual tuning and recall the
preset stations.
2. When above radio alarm time and station are set, press and hold
radio alarm button
switch alarm on or off. Display will show
is set.
Note:
If new radio alarm station is not selected, it will select the last
alarm station.
Setting the HWS (Humane Wake System)

buzzer alarm

A beep tone will activate when selecting the HWS alarm.
The alarm beep will increase in volume every 15 seconds for one
minute followed by one minute silence before repeating the cycle.
The HWS alarm will sound for one hour until turning off by pressing
the Power button. Press the Power button whilst the alarm is
activated will cancel the alarm for 24 hours.
1. The HWS buzzer alarm can be set either radio is on or off.
2. Press and release the HWS buzzer alarm button
the symbol
3. During the symbol flashes, long press the
than 2 seconds followed by a beep tone and display Hour digit
will flash.
9
for 2 seconds followed by a beep tone to
will flash.
when radio alarm
,
button for more