Recalling Preset Stations - Sangean H205 User Manual

Search tuning.
1. Press the Power button to turn on the radio.
2. Press the Band button to select the required band, then extend and position the wire antenna (FM) or
rotate the radio (AM) to get best reception.
3. Press and hold the Tuning Up/Down button to start the search tuning. Your radio will scan in an
upwards direction (low frequency to high frequency) or downwards direction (high frequency to low
frequency) and stop automatically when it finds a station of sufficient strength.
4. When the frequency band end is reached, the radio will continue tuning from the opposite frequency
band end.
5. Press the Volume Up/Down buttons to the required level.
6. To switch off your radio, press the Power button. The display will show "OFF".
Memory preset tuning
Storing stations in preset memories
There are 5 presets for each frequency band (FM1/FM2/AM/WX).
1. Press the Power button to turn on the radio.
2. Tune to the required station using one of the methods previously described.
3. Press and hold the required preset button more than 2 seconds until the preset number appears with
an M (memory) and then "Px" will show on the display. The station will be stored under the chosen
preset button.
4. Repeat the procedures for the remaining presets.
5. Stations stored in preset memories may be overwritten by following the above procedures.

Recalling preset stations

1. Press the Power button to turn on the radio.
2. Select the required frequency band by pressing the Band button.
3. Momentarily press the required Preset button, the preset number and station frequency will appear in
the display.
5