Snooze Function; Sleep Function - Sangean PR-D4 Operating Instruction

4. Using Tuning Up/Down button to select required alarm hour,
then press Scan button again. The Minute digit will then flash.
5. Using Tuning Up/Down button to select required alarm minute,
then press button again to complete alarm setting.
6. Press and hold down Buzzer alarm button
2 seconds followed by a beep tone to switch on or off the alarm.
Display will appear

Snooze function

1. Whilst the alarm is activated, press any buttons except the
Power button will active the snooze function. The radio or
HWS buzzer alarm will be silenced with interval of 5 minutes.
2. The display will flash both the snooze symbol
alarm symbol. The snooze function can be repeatedly during the
1 hour that the alarms are active.

Sleep function

The sleep timer will automatically switch off the radio after a preset
time has elapsed.
1. Press and continue to hold down the Power button for more than
2 seconds, followed by beep tone , the display will cycle through
the available sleep times in the order 60-45-30-15-120-90-60.
Release the Power button when the required sleep time appears
in the display. The
radio will play the last station selected .
2. To cancel the sleep function, press the Power button,
the symbol will disappear and radio is off.
when buzzer alarm has been set.
symbol will appear in the display and the
for more than
and the
GB
10