Table of Contents
Advertisement
116
D
escription of the SW2 configuration dip-switch of
the sound module.
The SW2 configuration dip-switch is located at the upper left
side of the back of the module.
For dip switch settings, use the tool
sound module.
Factory default
The switches set to OFF have null value. The values of the switches
set to ON are shown in the enclosed chart.
The backbone code will be calculated as the sum result of the
switches values set to ON.
Switch number:
ON value:
DOOR PANEL INSTALLATION
that is supplied with the
Allows to activate the autoswitch-on function (audio-video communication
without previous call) at the door panel that has this switch to ON position.
In systems with several door panels activate this function only in one of
them; in systems with general door panel this function can be activated in
one door panel of each inner backbone (building).
Set to ON for monitor or telephones programming. Once the programming
progress is finished return the switch to OFF position. The programming
process is described on pages 128 (monitors), 131 and 135 (telephones).
In general door panel (EL501 mode), set to ON for general door panel
push buttons programming or backbone (building) monitor/telephones.
The programming process is described on pages 117 to 119. Once the
programming progress is finished return the switch to OFF position.
Set to OFF in case of a master door panel. Each system must have only one
master door panel; the rest must be slaves (ON).
In systems with general door panel, set as master one door panel of each
inner backbone (building) and the general door panel as slave. Of this
way, the user will be able to distinguish since door panel are calling him.
Switches number 4 to 10 set the building code. In backbones with several
door panels, set the same code in all the panels; in systems with general
door panel, set different codes for each inner backbone (building). Set a
code between 1 and 120 for inner backbones (up to 127 with coded
panel) and a code 0 (
code use binary coding as shown on the next paragraph.
B
4
5
6
7
8
64
32
16
8
4
Factory default
) for general door panel/s. To set the
inary coding of the SW2 configuration dip switch
the sound module.
9
10
2
1
Example: 64+0+16+0+4+2+1=87
of
Advertisement
Table of Contents
