Depth Of Cut - Makita RP1800 Instruction Manual

Dust nozzle set (Accessory)
1
1. Dust nozzle
2. Clamping screw
009878
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
009877
How to use screw M6 x 135 for adjusting the

depth of cut

When using the tool with a router table available in the
market, using this screw allows an operator to obtain a
small amount of adjustment of the depth of cut from
above the table.
2
009934
2
1. Flat washer 6
2. Screw M6x135
1
1. Installing the screw and washer on the tool
Attach flat washer onto this screw.
•
Insert this screw through a screw hole in the tool
•
base and then screw in the threaded part in the
motor bracket of the tool.
1
009935
1
009929
1
009930
At this time, apply some grease or lubricating oil to the
inside of the screw hole in the tool base and the
threaded part in the motor bracket.
1
009932
11
1. Flat washer 6
2. Screw M6x135
2
1. Hole
1. Screw M6x135
2. Threaded part in
the motor
bracket
2
1. Inside of the
screw hole in
the tool base