Setup; Setup 1: Use The Stand; Setup 2: Connect The Cables - Sony MFM-HT205 Owner's Record

Setup

Before using your display, check that the following items are
included in your carton:
• LCD display
• Remote control
• Size AAA batteries (2)
• Mains lead
• HD15-HD15 video signal cable (analog RGB)
• DVI-D video signal cable (digital RGB)
• Audio cord (stereo miniplug)
• 75-ohm coaxial cable
• CD-ROM (utility software for Windows/Macintosh, Operating
Instructions, etc.)
• Warranty card
• Quick Setup Guide

Setup 1: Use the stand

x Using the supplied stand
Open the stand.
Note
The stand is folded at the factory. Be sure not to place the display
vertically with the stand as it is. Otherwise, the display may topple over.
x Using the VESA compatible stand
When using a non-supplied VESA compatible mounting arm or
stand, use the VESA compatible screws to attach.
screw positions of
the supplied stand
Bottom-side view
You can use the display with or without the supplied stand.
screw positions of VESA
compatible stand
(100 mm)
9

Setup 2: Connect the cables

• Turn off the display, computer, and other equipment
before connecting them.
• If you intend to connect:
– A computer equipped with an HD15 output connector
(analog RGB)
t See "Connecting a computer using the PC 2
connectors" (page 10).
– Video equipment that has component video output
jacks or a Scart connector
t See "Connecting video equipment using the
COMPONENT jacks" (page 11).
– Video equipment that has analog RGB/composite
video output jacks or a Scart connector
t See "Connecting video equipment using the
VIDEO 1 (Scart) jack" (page 11).
– Video equipment that has composite/S video output
jacks or a Scart connector
t See "Connecting video equipment using the
VIDEO 2 jacks" (page 12).
– An aerial
t See "Connecting an aerial" (page 12).
Notes
• Do not touch the pins of the video signal cable connector as this
might bend the pins.
• Be sure that the cables connected to the display does not get
pinched under the stand.
Remove the connector cover.
Push the hooks and draw the connector cover towards you.
GB
connector cover