Figure 5-9. Pulsed Cyclic Waveform Programming - National Instruments DAQ AT-MIO-16X User Manual

© National Instruments Corporation
Clear the analog output
circuitry including the
Y es
Set the A4RCV bit in
Command Register 2
Select the update counter
via RTSI programming
Program the update
interval counter
Program the cycle counter
Program the cycle interval
Set the waveform
generation mode
Enable updating
Service update requests

Figure 5-9. Pulsed Cyclic Waveform Programming

In this mode, Counter 1 counts the programmed number of cycles
before terminating the sequence. Counter 2 then begins counting the
time between cycles, the cycle interval, then restarts the sequence. This
START
DAC FIFO
No
Internal
update ?
counter
END
5-31
Chapter 5 Programming
Clear the A4RCV
bit in Command
Register 2
AT-MIO-16X User Manual