Battery Charging - Nilfisk-ALTO SCRUBTEC 343.2 User Manual

ENGLISH

BATTERY CHARGING

NOTE
Keeping the batteries charged make their life last longer.
CAUTION!
WARNING!
Do not smoke while charging the batteries.
WARNING!
1. Drive the machine to the appointed recharging area.
2. Make sure that the switches (62 and 63) are turned to "0".
3. For WET batteries only:
Remove the recovery tank as shown in Use chapter.
Check the level of electrolyte inside the batteries; if necessary, top up through the caps.
Leave all the battery caps open for next charging.
If necessary, clean the upper surface of the batteries.
4. Connect the battery charger cable (21) to the electrical mains (the electrical mains voltage and frequency must be compatible
with the battery charger values shown on the machine serial number plate (1)).
NOTE
5. When the green LED (27) stays on, the battery charging cycle is over.
6. When the battery charging is completed, disconnect the battery charger cable (21) from the electrical mains and wind it round
its housing.
7. For WET batteries only:
Close all the battery caps.
Install the recovery tank as shown in Use chapter.
8. Now the machine is ready to be used.
NOTE
22
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
SCRUBTEC 343.2 - 9099636000