Before Machine Start-Up - Nilfisk-ALTO SCRUBTEC 343.2 User Manual

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (54) or the pad-holder (55 and 56) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Turn the switch (62) to "I".
6. Press the brush enabling push-buttons (61) to engage the brush/pad-holder to the deck hub (10). If necessary, repeat the
procedure until the brush/pad-holder is engaged.
Available brushes and their relevant application guides (suggestions only)
Models
Concrete
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Squeegee installation
7. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
CAUTION!
WARNING!
8.
completely, leave few centimetres from the edge. Always follow the dilution instructions on the label of the chemical product
used to prepare the solution. The solution temperature must not exceed 40°C.
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
MIDLITE GRIT 180 MIDGRIT 240
9099636000 - SCRUBTEC 343.2
ENGLISH
PROLITE UNION MIX
13