Machine Transport/Parking; Tank Emptying - Nilfisk-ALTO SCRUBTEC 343.2 User Manual

ENGLISH
Machine speed adjustment
4.
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
Battery discharge during operation
5.
on in sequence, it is necessary to charge the battery as the machine residual autonomy is at the minimum level.
CAUTION!

MACHINE TRANSPORT/PARKING

To transport/park the machine, proceed as follows.
1. Turn off the machine by pressing the switches (62) and (63) to "0".
2. Lift the squeegee (59).
3. Engage the positioning pin (24) and activate the machine transport/parking device (23a) to keep the brush/pad-holder lifted
(Fig. 5).
4. While holding the machine in this position, drive it to the transport/parking area.
5.
the deck by using the disengagement procedure (see the next paragraph), then place it on the front holder (43).
Brush/pad-holder removal
Remove the brush/pad-holder deck by performing the following procedure:
1. Turn the switch (62) to "I".
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Press the switches (61) 3 times consequently, then wait that the brush starts and stop, thus disengaging from the drive hub.
4. Turn the switch (62) to "0" position to switch off the machine.

TANK EMPTYING

CAUTION!
When the recovery tank (30) is full, empty it according to the following procedure.
16
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
SCRUBTEC 343.2 - 9099636000
Figure 5
P100644