Figure E-4. Cover Removal - National Instruments SCXI-1121 User Manual

Insert Screwdriver in
Groove and Rotate to
Pry Open
SCXI-1302 Installation
© National Instruments Corporation
6. Snap the cover back in place.
7. Reinsert the rear grounding screw. The terminal block is now ready to
be connected to the front panel connector.
Grounding
Step 2
Follow these steps to install the SCXI-1302:
1. Install an SCXI-1180 feedthrough panel as described in the SCXI-1180
Installation section.
2. Wire the terminal block as described in the SCXI-1302 Wiring
Procedure section.
3. Connect the SCXI-1302 terminal block to the front panel connector on
the SCXI-1180 feedthrough panel. Be careful to fit the thumbscrews in
the thumbscrew cutouts.
4. Tighten the top and bottom captive screws on the back of the terminal
block into the screw holes in the front panel. This will hold the
SCXI-1302 securely in place.
5. Check the installation.
Screw
Step 1
Thumbscrew Cutout

Figure E-4. Cover Removal

E-11
Appendix E SCXI-1121 Cabling
50-Pin
Connector
SCXI-1121 User Manual