National Instruments SCXI-1121 User Manual page 125

SCXI-1340 Installation
© National Instruments Corporation
Table E-1. SCXI-1121 and MIO-16 Pinout Equivalences (Continued)
Pin
25
26
27
29
36
37
43
No other pins are connected on the SCXI-1121.
Follow these steps to install the SCXI-1340:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Plug the mounting bracket connector onto the module rear signal
connector (see Figure E-1). Make sure the alignment tab on the bracket
enters the upper board guide of the chassis.
4. Screw the mounting bracket to the threaded strips in the rear of the
chassis.
5. Connect the loose end of the cable assembly to the MIO-16 board rear
signal connector.
Check the installation.
After step 1, the order of these steps is not critical however, it is easier to
locate the correct position for the mounting bracket with a module installed
in the chassis. If you will attach a cable to the breakout connector,
installation is easiest if you attach the second cable before installing the
SCXI-1340.
SCXI-1121 Rear
Signal Connector
SERDATIN
SERDATOUT
DAQD*/A
SLOT0SEL*
SCANCLK
SERCLK
RSVD
E-3
Appendix E SCXI-1121 Cabling
MIO-16 Equivalent
ADIO0
BDIO0
ADIO1
ADIO2
SCANCLK
EXTSTROBE*
OUT1
SCXI-1121 User Manual