Mains Power Connection; External Unit - TechniSat TechniCorder ISIO STC Quick Start Manual

4.1 Mains power connection

The digital receiver should only be connected to the mains power supply once you have fin-
ished making all the connections to the various other components. This will prevent damage
to the digital receiver or other components.
Once you have made all the other connections in accordance with the following sec-
a
tions, use the power cable supplied to connect the receiver to 230 V/50-60 Hz mains
power outlet.

4.2 External unit

4.2.1 Operating the receiver with 2-4 DVB-S antenna signals
To be able to use the full scope of DVB-S functions on the digital receiver you should oper-
ate the receiver on up to four separate DVB-S antenna signals/antenna cables that which
are set up identically.
If you have not installed an additional DVB-S tuner module:
Connect LNB inputs 1 and 2 on the digital receiver to your external unit using
b, c
a suitable coaxial cable.
or if you have installed an additional DVB-S tuner module:
b, c, i, h Connect LNB inputs 1 and 2 and LNB inputs 3 and 4 with your external
unit using a suitable coaxial cable.
Also see section 8.6 (DVB-S antenna setting) in your operating manual.
4.2.2 Operating with 1 DVB-S antenna signal
In exceptional cases you can also operate the receiver using just one DVB-S antenna sig-
nal. However, in this event the recording and PIP functions are only available to a limited
extent. (see section 8.6.3 in your operating manual).
If you have not installed an additional DVB-S tuner module:
Connect the LNB Input 1 of the digital receiver to your external unit using
b
a suitable coaxial cable
or if you have installed an additional DVB-S tuner module:
Connect the LNB Input 3 of the digital receiver to your external unit using
h, j, b
a suitable coaxial cable. Now also connect the loop out output with the LNB
input 1.
Also see section 8.6 (DVB-S antenna setting) in your operating manual.
4.2.3 Operating with DVB-C/T antenna signals
The digital receiver can receive signals to DVB-C or DVB-T standard. Reception in parallel
with DVB-S reception is also possible
If you have not installed an additional DVB-C/T tuner module:
Connect the RF IN antenna input on the digital receiver to your external unit
g
using a suitable coaxial cable.
or if you have installed an additional DVB-C/T tuner module:
Connect the antenna Input RF INon the digital receiver to your external unit
g, k, l
using a suitable coaxial cable. Now also connect the loop out output with the
LOOP IN antenna input of the tuner module.
14