Table of Contents
Advertisement
4.1 Mains power connection
The digital receiver should only be connected to the mains power supply once you have
finished making all the connections to the various other components. This will prevent
damage to the digital receiver or other components.
a
Once you have made all the other connections in accordance with the following
sections, use the mains adapter supplied to connect the receiver to a 230 V / 50-60 Hz
mains power outlet.
4.2 External unit
4.2.1 Operating with 2 DVB-S antenna signals
To be able to use the full scope of DVB-S functions on the digital receiver you should
operate the receiver on two separate antenna signals / antenna cables that are set up
identically.
b, c
Connect the LNB inputs 1 and 2 on the digital receiver to your external unit
using a suitable coaxial cable.
Also, note Point 8.6 (DVB-S antenna configuration) in your operating manual.
4.2.2 Operating with 1 DVB-S antenna signal
In exceptional cases, you can also operate the receiver using just one DVB-S antenna
signal. However, in this event the recording and PiP functions are only available to a limited
extent. (see Point 8.6.3 in your operating manual)
b
Connect the LNB input 1 on the digital receiver to your external unit using a
suitable coaxial cable
Also, note Point 8.6 (DVB-S antenna configuration) in your operating manual.
4.2.3 Operating with DVB-C / T antenna signals
The digital receiver can receive signals according to the DVB-C or DVB-T standard. As an
option, reception parallel to the DVB-S is also possible.
g
Connect the RF IN antenna input on the digital receiver to your
external unit using a suitable coaxial cable.
Also, note Point 8.7 (DVB-T antenna configuration) in your operating manual.
It is not possible to receive analogue television via a cable or antenna!
4.2.4 Operating with a rotating system
b
During operation on a rotating system, connect the DiSEqC motor (level 1.2) with LNB
input 1.
4.3 Connecting to a TV
d
Connect the receiver (HDMI output) and TV (HDMI input) using an HDMI cable.
If your TV is appropriately equipped, it will automatically switch to the HDMI input
when the digital receiver is switched on.
11
Advertisement
Table of Contents
