Table of Contents
Advertisement
Install the camera
6
Install the camera
6.1
Installation
6.1.1
Using BNC composite video output
6.1.2
Using twisted pair video output
18
Siemens Building Technologies
Fire Safety & Security Products
1.
Connect BNC cable to video output, please refer to chapter 5.1 Camera part
definition.
2.
Connect power source to power terminal.
3.
To reduce radiation sufficiently, please wind one turn around the core, see
figure below.
Location
Core illustration
Power cable
Power cable
Y/C cable
If using a DC supply, make sure the polarity is correct. Incorrect connection may
CAUTION
cause malfunction and / or damage to the camera.
4.
Adjust backfocus: The backfocus is adjusted in the factory for a CS mount
lens as shipped, if re-adjust is necessary, please unlock screw. Enter Back
Focus Format in OSD (please refer to chapter 6.2.4.8), then rotate backfocus
wheel till a sharp image appears. Lock the screw tightly.
1.
Connect BNC cable to video output, please refer to chapter 5.1 Camera part
definition.
2.
Make sure that a proper BNC 75 Ohm cable is used.
3.
Switch on 75 Ohm termination in video receive equipment such as Monitor,
matrix or equivalent
1.
Connect twisted pair cable to TP-Output of camera, please refer to chapter
5.1 Camera part definition
2.
Connect suitable twisted pair receiver device (i.e. TP-RXMOD2)
3.
Setup TP transmitter using DIP-switches, please refer to chapter 5.2.1.
4.
Adjust twisted pair receiver to get best quality video-output, please refer to the
instruction manual of used twisted pair receiver
Camera type
LX
MX
LX / MX
08.2006
Advertisement
Table of Contents
