Camera Cabling; Connect Power; Connect Ethernet Cable - Siemens CCMS2010-IRW User Manual

Camera cabling

8 Camera cabling
8.1

Connect Power

CCMS2010-IR
CCMS2010-IRW
8.2

Connect Ethernet Cable

CCMS2010-IR
CCMS2010-IRW
16
Siemens AB
Security Products
Please follow the instructions below to complete IP Camera connection.
Please refer to section
era by PoE. Use an Ethernet cable and connect it to the camera and a PoE
switch.
NOTE: If PoE is used, make sure Power Sourcing Equipment (PSE) is in used in
the network.
Please refer to section
ply Adapter connecting with the Micro USB cable into the power outlet, and con-
nect the other end of the cable to the camera's Micro USB port. Alternatively, con-
nect the Micro USB Cable to the Micro USB port of the camera and plug the other
end of the cable into the USB port of the computer.
Use of Category 5 Ethernet Cable is recommended for network connection. To
have best transmission quality, cable length shall not exceed 100 meters. Connect
one end of the Ethernet cable to the PoE Network connector of the IP Camera,
and plug the other end of the cable to the network switch or PC.
NOTE: In some cases, Ethernet Crossover cable might be needed when connect-
ing the IP Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are
unlit, please check LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
Check the status of the Wireless LAN (WLAN) LED. If the LED is unlit, please
check if the camera is connected to the network.
7.3 Connectors. Alternatively, users can power the cam-
7.3 Connectors. Plug the camera's Micro USB Power Sup-
05.2014