Table of Contents
Advertisement
Install the camera
6.2.3.1 D/N MODE
6.2.3.2 D/N LEVEL
6.2.3.3 D/N DELAY
6.2.4
OPTION
22
Siemens Building Technologies
Fire Safety & Security Products
Select Day/Night function automatically, color or
mono. Move the cursor to the position as shown
in the figure. Use the UP/ DOWN button to se-
lect AUTO, MONO or COLOR mode.
AUTO: When set to this mode, the camera will
change to COLOR mode or B/W mode auto-
matically depending on a subject's brightness.
MONO: When set to this mode, the camera
will remain in monochrome mode always.
COLOR: When set to this mode, the camera
will remain in COLOR always.
Select filter switchover point High, Low or Mid-
dle.
Set up a switchover point from COLOR mode to
B/W mode. Move the cursor to the position as
shown in the figure. Use the UP/DOWN button
to select HIGH, LOW or MID. The level only
affects when the D/N mode set as AUTO.
A. LOW: The switchover point of gain from
COLOR into B/W mode is 21 dB, and back to
COLOR mode point is 18 dB.
B. MID: The switchover point of gain from
COLOR into B/W mode is 22 dB, and back to
COLOR mode point is 18 dB.
C. HIGH: The switchover point of gain from
COLOR into B/W mode is 23 dB, and back to
COLOR mode point is 18 dB.
Setting DELAY time for D/ N function.
Move the cursor to the position as shown in the
figure.
Use the UP/ DOWN button to select 0, 5, 10, 15
or 20 sec for delay of into D/N mode timing.
This function only affects when D/N Mode to be
set as AUTO.
Enter OPTION submenu as shown in the figure.
Using UP/DOWN Key to adjust cursor to the
function which wants to modify.
Press ENTER key to enter Modify status and
then using UP/DOWN key to select Mode after
selected and then press Enter key to leave
modify status.
D/N SETUP
D/N MODE AUTO
D/N LEVEL MID
D/N DELAY 5
BACK
D/N SETUP
D/N MODE AUTO
D/N LEVEL MID
D/N DELAY 5
BACK
D/N SETUP
D/N MODE AUTO
D/N LEVEL MID
D/N DELAY 5
BACK
OPTION
MIRROR OFF
<DZOOM>
CHROMA 3
COLOR BAR OFF
DNR OFF
<BACKFOCUS>
SYSTEM PAL
BACK
08.2006
Advertisement
Table of Contents
