Table of Contents
Advertisement
2
General guidelines
Siemens Building Technologies
Fire Safety & Security Products
Read instructions:
All the safety and operating instructions should be read before the product is op-
erated.
Retain instructions:
The safety instructions and the instruction manual should be retained for future
reference.
Heed warnings:
All warnings on the product and in the instruction manual should be adhered to.
Follow instructions:
All operating and use instructions should be followed.
Attachments:
Do not use attachments not recommended by the video product manufacturer as
they may cause hazards.
Water and moisture:
Do not use this video product near water, for example near a bath tub, wash
bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool
and the like.
Accessories:
Do not place this video product on an unstable cart, stand, tripod, bracket or ta-
ble. The video product may fall, causing serious injury to a child or adult, and se-
rious damage to the product. Use only with the stand, tripod, bracket, or table
recommended by the manufacturer or sold with the video product. Any mounting
of the product should follow the manufacturer's instructions, and should use a
mounting accessory recommended by the manufacturer.
Ventilation:
This video product should never be placed near or over a radiator or heat regis-
ter.
Power sources:
This video product should be operated only from the type of power source indi-
cated on the marking label. If you are not sure of the type of power supply to
your location, consult your product dealer.
Power-cord protection:
Power supply cords should be routed so that they are not likely to be walked on
or pinched by items placed upon or against them, paying particular attention to
cords at plugs, screws and the point where they exit from the product.
Lightning:
For added protection for this video product during a lightning storm, or when it is
left unattended and unused for long periods of time, unplug it from the wall outlet
and disconnect the power supply and cable system. This will prevent damage to
the video product due to lightning and power-line surges.
Overloading:
Do not overload power supply and extension cords as this can result in a risk of
fire or electrical shock.
General guidelines
7
08.2006
Advertisement
Table of Contents
