Install the camera
6.2.9
SYNC MODE
6.2.10 BACK
6.2.11 EXIT
6.2.12 CANCEL
6.2.13 DEFAULT
30
Siemens Building Technologies
Fire Safety & Security Products
Move the cursor to the position as shown in the
figure.
Push Enter and using UP / DOWN button to
choose INT or LL. This function only works on
AC power.
A. INT; The camera is in the internal SYNC
mode.
B. LL: The camera is in the line lock mode, you
can adjust the phase angle from 0 - 300 deg
according. The default is 300 deg.
Selection of next page and last page.
Save all setting and exit.
Reset back to original settings.
Recall factory settings.
MAIN MANU
PRESET INROOM
<CAMERA SETUP>
<D/N SETUP>
<OPTION>
<OTHER SETUP>
<REMOTE>
<PRIVACY ZONE>
BLC ZONE OFF
SYNC MODE INT
EXIT CANCEL DEFAULT
08.2006