Motion; Motion Level; Motion Area; Set Zone Posi - Siemens CCWC1345-LX Configuration Manual

Install the camera

6.2.5.6 MOTION

6.2.5.7 MOTION LEVEL

6.2.5.8 MOTION AREA

6.2.5.9 SET ZONE POSI

6.2.5.10 SET ZONE SIZE

26
Siemens Building Technologies
Fire Safety & Security Products
Enter MOTION submenu as shown in the figure.
Using UP/DOWN Key to adjust cursor to the
function which wants to modify.
Press ENTER key to enter Modify status and
then using UP/DOWN key to select Mode after
selected and then press Enter key to leave
modify status.
When MOTION set ON and image has bigger
Change. It will trigger alarm.
Enter MOTION item as shown in the figure.
Press ENTER key to enter Modify status and
then using UP/DOWN key to Select Mode ON
OR OFF after selected and then press Enter
key to Leave modify status.
Setting the motion detect sensitivity. Use the
UP/DOWN keys to set the sensitivity in the
range of 0 to 255. The value "0" corresponds to
the highest sensitivity.
Enter MOTION AREA submenu as shown in
the figure.
Using UP/DOWN Key to adjust cursor to the
function which wants to modify.
Press ENTER key to enter Modify status and
then using UP/DOWN key to select Mode after
selected and then press Enter key to leave
modify status.
Setting the alarm zone position.
Changing the alarm zone size.
OTHER SETUP
CAMERA ID
-----------------------------
<ALARM>
<MOTION>
BACK
MOTION OFF
MOTION LEVEL LOW
<MOTION AREA>
MOTION TEXT
------------------------------
ALARM OUT OFF
MOTION DELAY 5
BACK
MOTION OFF
MOTION LEVEL 15
<MOTION AREA>
MOTION TEXT
------------------------------
ALARM OUT OFF
MOTION DELAY 5
BACK
MOTION OFF
MOTION LEVEL LOW
<MOTION AREA>
MOTION TEXT
------------------------------
ALARM OUT OFF
MOTION DELAY 5
BACK
SET ZONE > < ^ v POSI
SET ZONE > < ^ v SIZE
08.2006