Mounting And Connecting The Gigaset Wlan Camera - Siemens A31008-M1026-R101 Manual

Mounting and connecting the Gigaset WLAN Camera

!
Protect the Gigaset WLAN Camera against falling down. Even during
installation, mount the stand and secure it against tilting.
ì
Mount the camera on the supplied base and stand.
– Join the base, stand and swivel connector to the camera, as shown in the diagram
above.
The thread of the camera is the same as that of a standard tripod,
i
instead of the supplied accessory you can use your tripod for mount-
ing.
ì
Connect the LAN cable.
– Connect the Gigaset WLAN Camera to a 10/100BaseT hub or switch.
Connecting the LAN cable disables the wireless interface, because
only one interface can be active. The LAN interface is recommended
for initial configuration.
i
The default wireless settings for the Gigaset WLAN Camera are:
Mode: Infrastructure
SSID: ANY
Security features: Disabled
ì
Adjust the antenna.
– Screw the antenna to the rear mounting point.
– Set the antenna to the upright position to improve wireless reception.
Basic Setup
11