Assembly - Yeti Cycles ASR 08 Owner's Manual

Assembly

Yeti tiPs
Make sure your tools are in good condition. A
worn allen key can round the hex on a bolt
preventing proper torque. Be careful when using
ballpoint allen wrenches for the same reason.
Torque settings are listed throughout the
instructions. It is also important to prep all bolt
threads. The instructions denote whether to use
a blue Loctite compound or grease.
assemblY 20
tOOls neeDeD
Dead blow hammer
Adjustable pliers
Two - 5mm allen keys
6mm allen key
4mm allen key
4mm t-handle allen key
Linkage tool
time
30-45 minutes depending
on condition of the bike
The linkage tool is necessary to properly
disassemble and reassemble the linkage. Using
a hammer to tap out the pin can cause damage
to the linkage and shock.
Not every tool may be needed for the assembly /
disassembly of your bike. The list encompasses
all the tools necessary to completely assemble
and disassemble a each bike.
Warning:
Service on Yeti bicycles requires special
knowledge and tools. Yeti Cycles recommends that all
service and repairs be performed by an authorized Yeti
dealer.