Yeti Cycles ASR 08 Owner's Manual page 11

Assembly
DOGbOne & shOCk setuP Slide bearings flush into bottom of
1
dogbone with shoulder facing out.
tip: Shoulder is part of bearing that sticks out.
DOGbOne & shOCk mOuntinG assemblY Insert pinch bolts into
2
bottom of dogbone. Snug pinch bolts just tight enough to hold. They
will be completely tightened at a later step.
DOGbOne & shOCk mOuntinG assemblY Now insert 15mm
3
reducers into shock and hammer into place with dead blow hammer.
DOGbOne & shOCk mOuntinG assemblY Hang shock and dogbone
4
separately off of frame. Insert 31.0mm Ti female bolt through drive
side (the right side when standing behind the seat tube) for the shock.
Use Ti male bolt on non-drive side to tighten shock into place with 5mm
allen key.
tip: Don't over-torque Ti bolts or they may fracture.
assemblY 22
threaD PreP Yeti recommends prepping all bolt threads
at once on your work bench with Loctite or grease. This will
ensure that all bolts are used in assembly. The medium
strength (blue) Loctite formula along with proper torque is
ideal to keep the bolts snug.
rear trianGle assemblY Install the dogbone using the 40.5mm
5
Ti female bolt and the Ti male bolt. With Yeti logo facing rear of frame
(dogbone looks C-shaped), use dead blow hammer to insert 40.5mm Ti
female bolt through top of dogbone that connects to dogbone mount on
frame. Use Ti male bolt on non-drive side to tighten dogbone into place
with 5mm allen key.
tip: If needed you can use dead blow hammer to help with female bolt
installation.
rear trianGle assemblY Pull the shock and dogbone together so
6
that they line up.
Tip: If the spacing is too tight, loosen the pinch bolts. This will allow you
to get the proper spacing for the shock and dogbone. Now make sure
the bearings are flush against the shock reducers in the shock. Wait to
tighten down dogbone pinch bolts to keep the Ti studs from binding during
installation.
mOuntinG rear trianGle Press the bearings into the seatstays
7
of the rear triangle with shoulders facing in. Loctite pinch bolts and
tighten into seatstay of the rear triangle. Slide the swing arm over the main
pivot using the indentions in the swing arm to align.
tip: Wait to tighten down dogbone pinch bolts. This will keep Ti stud from
binding during installation process.
mOuntinG rear trianGle Install the Fox Guide Pin in the
8
seatstays, dogbone and shock to hold and align the three together.
Use a dead blow hammer to hammer into place.