Putting The Radio Cell Into Maintenance Mode - Siemens FDCW241 Technical Manual

7 Maintenance / troubleshooting

Putting the radio cell into maintenance mode

7.2 Putting the radio cell into maintenance mode
36
Building Technologies
Fire Safety
Radio gateway FDCW221
H2 Yellow LED for maintenance mode
S1 Button for maintenance mode
The housing for the radio gateway is open.
The radio gateway is in normal operation.
1. Switch off the relevant zone on the station.
LED (H2) is not flashing.
2. Press and hold button (S1) for at least 2 seconds until LED (H2) flashes.
The radio gateway and its radio cell are in maintenance mode.
LED (H2) flashes at 1-second intervals.
The radio devices can now be logged on.
You will find more information in the 'Change and extend the detector line' chapters
of the following documents:
For control panels FC20xx: Document 009052
For control panels FC72x: Document A6V10210416
See also
Applicable documents [
H2
S1
7]
A6V10227639_e_en_--
2013-09-01