Building Technologies
Fire Safety
-
Openings in the supporting surface for recess-mounted cables.
-
Openings in the narrow side for surface-mounted cables.
5. Insert the cables into the back box.
6. Install the back box, without the battery pack, on a flat surface using two
screws (Ø max. 4.3 mm) at the mounting points (2). One screw at mounting
point (3) is sufficient for fixing in housing FDCH221.
7. Fasten the cable using a cable tie as strain relief (5).
8. Label the battery pack with the date.
9. Insert the battery pack and check the position of the battery cable. Do not
connect the battery pack until you are ready to commission the radio cell.
The radio gateway is installed.
See also
Commissioning [
Connecting the radio gateway [
Mounting/Installation
Installation
30]
27]
A6V10227639_e_en_--
5
25
2013-09-01