Table of Contents
Advertisement
5
Mounting/Installation
Installation
5 Mounting/Installation
5.1 Installation
24
Building Technologies
Fire Safety
167 mm
28 mm
2
1
Installing the radio gateway
1 Screw
2 Mounting points
3 Mounting point for installation in housing FDCH221
4 Cable entries
5 Strain relief fastenings
You have the radio gateway, battery pack, fixing screws, and cable tie to hand.
You have the device location plan to hand.
The connection cable has a wire diameter of 0.2...1.5 mm².
The lines to the installation location are installed.
Two fixing screws (Ø max. 4.3 mm) are to hand.
1. Determine the installation location:
-
The housing must be positioned in accordance with the planning
specifications (make sure there is a wide radio range and that the housing
can be accessed easily).
-
Make sure there is enough space for you to open the housing cover easily.
-
The housing may be installed in any appropriate position.
2. Open the housing:
-
Remove the screw (1).
-
Use a pen or pencil (A) to unlock the housing cover.
-
Lift the housing cover and remove it (B).
3. Remove the adhesive label bearing the serial number from the back box and
use it to mark the installation location on the device location plan.
4. In the back box, break out the plastic for the cable entry (4):
89 mm
142-147 mm
3
2
1 1 1 3
4
5
1 1 1 4
1 1 1 5
A6V10227639_e_en_--
2013-09-01
Hide quick links:
Advertisement
Table of Contents
