Basic Principles For Replacing The Battery Pack - Siemens FDCW241 Technical Manual

Hide thumbs Also See for FDCW241:

Table of Contents

Maintenance / troubleshooting

Basic principles for replacing the battery pack

7.7 Basic principles for replacing the battery pack

Building Technologies

Fire Safety

CAUTION

Risk of explosion due to fire or short-circuit, even if the battery pack is empty

Injuries caused by flying parts

To prevent the connection wires short-circuiting, insulate the connections and

stick the battery cable to the battery pack.

Do not allow the battery pack to come into contact with water.

Do not extinguish a burning battery pack with water.

Do not recharge the battery pack.

Do not damage or dismantle the battery pack.

Do not heat the battery pack to more than 100 °C.

CAUTION

Disposing of damaged or leaky battery packs

Lithium can burn the skin and produce toxic vapors.

Avoid direct contact with the body. Wear appropriate protective clothing

(safety gloves, safety goggles, etc.). Use appropriate means of transportation

to move damaged batteries around.

Do not breathe in vapors. Ensure that there is sufficient ventilation.

Always observe the following information:

When the control panel issues the message 'Battery low', replace the battery

pack. The message 'Battery empty' is issued as a fault.

Use the control panel to identify the location of the radio device.

Only use battery pack BAT3.6-10.

The battery pack must be new and free from damage. The battery cable is

attached to the battery pack with an adhesive label.

Store, transport, and dispose of the battery pack in accordance with local

regulations, guidelines, and laws.

Label the battery pack with the commissioning date.

Table of Contents