Start The "Mobile Radio Monitor" Function; Start The "Scan" Function; Start The "Info" Function; Exit The Control Menu - Siemens WTT568 Series Operating And Installation Instructions

Switch to the "MOBILE" display mode.
Press the function key long to start the "Mobile radio monitor" function.
• The buzzer generates a short tone.
• The LED flashes green.
• The display shows the "MOBILE" message with antenna symbol
The mobile radio signal strength is updated and displayed every 5 seconds. If the mobile radio signal is too weak,
change your position until you have determined the best possible position for installing the gateway. The duration of
the mobile radio check is limited to 3 min 45 sec. Afterwards the mobile radio check is ended automatically.
Switch to the "SCAn" display level.
Press the function key long to start the scanning process.
• The buzzer generates a short tone.
• The LED flashes green.
• The display shows the "SCAn" message with flashing Rx symbol.
• The remaining sequence of the scanning process then takes place in the same way as
Switch to the "InFo" display level.
Start the function with a long press on the function key.
• The buzzer produces a short tone.
• The display shows the following information in succession:
You can end the function by pressing the function key for a long time. Alternative: The
function ends automatically after 5 minutes.
Switch to the "EXIT" display level.
Press the function key long to exit the Control menu.
19.04.2022
signal strength and the symbol for the mobile phone standard available at the location:
– = 2G (GSM, GPRS, EGPRS)
– = 3G (UMTS, HSDPA, HSUPA)
– & = 4G (LTE-FDD)
the scanning process described in Section
– Firmware version
– Date of the next connection
– Time of the next connection
Operation and use | EN
, the mobile radio
"Manual installation (Auto scan)".
112