Cisco 2600 Series Operation Manual page 110

Hide thumbs Also See for 2600 Series:
Table of Contents

Advertisement

Adding 6-Port MICA Modules to a Digital Modem Network Module
Removing the Digital Modem Network Module
Caution
avoid damaging the module, before you remove a network module from a chassis slot, you
must turn OFF electrical power and disconnect network cables.
Follow this procedure to remove a digital modem network module:
Step 1
Warning
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker
on the panel board that services the DC circuit, switch the circuit breaker to the OFF
position, and tape the switch handle of the circuit breaker in the OFF position.
Step 2
Step 3
Step 4
10-8
Cisco Network Modules Hardware Installation Guide
Network modules do not support online insertion and removal (hot swap). To
Turn OFF electrical power to the router. However, to channel ESD voltages to
ground, do not unplug the power cable. Remove all network interface cables,
including telephone cables, from the rear panel.
The following warning applies to routers that use a DC power supply:
Before performing any of the following procedures, ensure that power is
Loosen the module's captive mounting screws, using a Phillips or flat-blade
screwdriver.
Hold the captive screws between two fingers, and pull the network module
toward you until it slides free of the chassis. (See Figure 10-4.)
Set the network module on an ESD-preventive mat.

Advertisement

Table of Contents
loading

This manual is also suitable for:

3600 series

Table of Contents