Cisco 2600 Series Operation Manual page 27

Hide thumbs Also See for 2600 Series:
Table of Contents

Advertisement

You need either a number 1 Phillips screwdriver or a flat-blade screwdriver. To install a
WAN interface card, follow this procedure:
Step 1
Step 2
Step 3
Figure 3-3
Installing a WAN Interface Card in a Network Module (Typical)
B 1
B 2
B R I
S /T
BRI S/T
WAN interface card
Step 4
Installing a WAN Interface Card in a Network Module Slot
If you are installing the card directly into a base module in the router, turn OFF
power to the router. However, to channel ESD voltages to ground, do not unplug
the power cable. Remove all network interface cables, including telephone
cables, from the rear panel.
If you are installing the card into the base module outside the router, attach an
ESD-preventive wrist strap and ensure that it makes good contact with your skin.
Connect the equipment end of the wrist strap to an electrical ground.
Using a Phillips or flat-blade screwdriver, remove the blank filler panel from the
base module slot where you plan to install the card. Save the filler panel for
possible future use.
Align the card with the guides in the module slot and slide it gently in. (See
Figure 3-3.)
2 E
2 W W 1
E T H 1
Push the card into place until the edge connector is securely seated in the
connector on the module.
Installing Network Modules in Cisco Modular Routers 3-5
W O
A U I
E T H E R
N E T 0
E N
Module

Advertisement

Table of Contents
loading

This manual is also suitable for:

3600 series

Table of Contents