Cisco 2600 Series Operation Manual page 53

Hide thumbs Also See for 2600 Series:
Table of Contents

Advertisement

Connecting Serial Network
Modules to a Network
This chapter describes how to connect and configure serial network modules in Cisco
modular routers, and describes the following:
About Serial Connections on page 6-1
Connecting Asynchronous Network Modules to Asynchronous Devices on page 6-4
Asynchronous Network Modules Interface Numbering on page 6-5
4-Port Serial Network Module on page 6-10
16-Port and 32-Port Asynchronous Serial Network Module on page 6-13
4-Port and 8-Port Asynchronous/Synchronous Serial Network Module on page 6-15
About Serial Connections
Serial connections are provided by the WAN interface cards and network modules. The
serial WAN interface card can be installed in either slot of a 2-slot module. For more
information on WAN interface cards, see the publication Cisco WAN Interface Cards
Hardware Installation Guide.
Before you connect a device to a serial port, you need to know the following:
Type of device, data terminal equipment (DTE) or data communications equipment
(DCE), you are connecting to the synchronous serial interface
Type of connector, male or female, required to connect to the device
Signaling standard required by the device
C H A P T E R
Connecting Serial Network Modules to a Network 6-1
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

3600 series

Table of Contents