Connecting Fast Ethernet Channelized T1 Modules to the
Network
In order to connect Fast Ethernet channelized T1 modules to the network, complete the
following:
•
Connecting the Fast Ethernet Port on page 5-3
•
Connecting the PRI Ports on page 5-4
Connecting the Fast Ethernet Port
Use a straight-through two-pair Category 5 unshielded twisted-pair (UTP) cable to connect
the RJ-45 port on the Fast Ethernet PRI network module to a switch, hub, repeater, server,
or other network device. These ports are color-coded yellow. Figure 5-3 shows the RJ-45
port connected to a hub.
Note
available and must be Category 5 cables.
Connecting Fast Ethernet Channelized T1 Modules to the Network
RJ-45 cables are not available from Cisco Systems. These cables are widely
Connecting Fast Ethernet PRI Network Modules to a Network 5-3