AUI Connections
Use an Ethernet AUI cable to connect the AUI port on the 1-port or 4-port Ethernet network
module to an Ethernet transceiver. The female end of the AUI cable mates with the
slide-latch connector of the transceiver cable. Figure 4-3 shows a thin Ethernet transceiver
as an example, but you can use any type of Ethernet transceiver.
Figure 4-3
ETHERNET
4E
Ethernet AUI cable
(not supplied)
If the transceiver cable has thumbscrew connectors, you can connect it directly to the AUI
port by replacing the AUI port slide latch with a jackscrew (provided in a separate bag).
10BaseT Connections
Use an Ethernet 10BaseT cable to connect a 10BaseT port on the 1-port or 4-port Ethernet
network module to a hub or other network device. Figure 4-4 shows the 10BaseT port on
an Ethernet network module connected to a hub.
Connecting an Ethernet AUI Port to a Transceiver
ETH 3
ETH 2
ETH 1
ETH 0
3 2 1
0
LINK
ACT
Ethernet AUI port (DB-15)
(with jackscrews or slide-latch)
BNC connector
To thin Ethernet network
EN
Ethernet
transceiver
To thin Ethernet network
Connecting Ethernet Network Modules to a Network 4-3
Connecting Ethernet Ports