Yale HSA6200 Installation, Programming, Operating page 11

2 Perform a radio range test by pressing Test/Learn
Button on the door/window contact; siren will
beep once. Each press on the button results
a beep on the siren.This indicates the device
is within range. If this step fails please find an
alternative location to place your door/window
contact.
Mounting using adhesive pads
1 Clean the mounting surface with a suitable
degreaser agent.
2 Remove the protective film from one side of the
adhesive pad and apply to the back of the sensor
and magnet
3 Remove the remaining protective film and firmly
press into place.
4 Test sensor by pressing the test button and
opening and closing the door/window. The LED
should light when the door/window is opened.
Installation is complete.
Mounting using screws and wall plugs
1 Loosen the bottom screw and open the door/
window contact.
2 Knock out the holes on the
base as shown.
3 Drill holes into the
mounting surface using
the holes in the knockouts
on the base as template.
4 Fit wall plugs (if required)
and secure with the
screws provided.
5 Fit sensor back together and tighten screw.
6 Test sensor by pressing the test button and
opening and closing the door/window. The LED
should light when the door/window is opened.
Installation is complete.
Knockouts
Mounting the Help button
1 Break through the knockouts (where the plastic is
thinner).
2 Using the holes as a template, drill holes in the
surface and insert wall plugs if fixing into plaster or
brick. Screw the rear case to the wall.
3 Replace the cover and tighten the screw.
Mounting the Smoke Detector
1 The base has two mounting slots. Using the slots
as a template, drill holes and insert the wall plugs if
fixing to plaster. Screw the rear case to the ceiling
using the screws provided.
2 Replace the cover.
Final step:
After mounting the detectors, please enable the
system tamper by:
Keypad: Panic button A followed by "0000" then
press panic button A followed by "3".
Keyfob: Press "Arm" and "Panic" together for
5 seconds.
11