Gs-2108C Packing List; Quick Installation; Power Requirements - Ruby Tech GS-2108C User Manual

GS-2108C Packing List :

Before you start installing GS-2108C Managed Switch, please verify that the package
contains the following items:
8 Port Gigabit L2 Managed Switch
AC Power Cord
User' s Guide CD-ROM
RS-232 Null Modem Cable
Please notify your sales representative immediately if any of the aforementioned items is
missing or damaged.

Power Requirements :

Voltage
Frequency
Consumption

Quick Installation :

1. Install the switch in the rack with mounting accessory.
2. Connect the GS-2108C switch to an AC power source.
3. The port 1–8 connector is RJ-45 jack on the switch. Use Category 5 UTP cable to
connect between GS-2108C and end station.
4. The port 7, 8 includes two types of media --- TP and SFP fiber module; they support TP
or fiber with auto-detected function.
5. Use RS-232 interface to pre-configure GS-2108C for network management.
For example: IP address, VLAN, Port Trunking, STP, etc.
GS-2108C switch' s serial port default settings are listed as follows:
Baud rate
Stop bits
Data bits
Parity
Flow control
The default values of GS-2108C switch are as follows:
IP Address
Subnet Mask
Default Gateway
Username
Password
User also can use telnet or web to pre-configure GS-2108C with the default IP address
and username/password in the first configuration. Please refer to User' s Guide contained
in CD-ROM for details on the setting of parameters. GS-2108C user' s manual is filed
under the path: \manual of the CD-ROM.
Read Me First
AC Line
: 100∼240 VAC
: 50∼60 Hz
: 13W
2F, No.7, Lane 50, Nan Kang Road, Sec. 3, Taipei, Taiwan
Email: rubytech@mail.rubytech.com.tw
TEL: 886-2-2785-3961
© 2005 Copyright by Ruby Tech Corporation and all rights reserved.
(625-0531-010)
57600
1
8
N
none
: 192.168.1.1
: 255.255.255.0
: 192.168.1.254
: admin
: admin
Ruby Tech Corp.
FAX: 886-2-2786-3012