Junction Box Installation; Junction Box Mounting - Datalogic DS6100 Installation Manual

DATALOGIC

2.4 JUNCTION BOX INSTALLATION

The junction box provides a passive connection between your scanner and
the outside world in a fast and practical way. It represents an alternative to
other standard connectors provided. Figure 2.7 shows the basic layout of a
scanner using the junction box.
For junction box connections, the scanner has a cable that terminates in a
24-pin connector that plugs into the
junction box. The system cables
pass through 6 glands in the side of
the junction box and the individual
wires connect
terminal blocks inside which provide
access to all scanner signals.
Refer to Figure 2.6 for the overall dimensions of the junction box.

2.4.1 Junction Box Mounting

The junction box is designed to be mounted to a panel of metal, plastic or
other appropriate material using the mounting screws provided in the
package. To do this:
1) Open the junction box by unscrewing the 4 cover screws.
If necessary, using the two mounting holes inside the junction box as a
pattern, mark
appropriate object and then drill two small
pilot holes in the panel.
2) Align the junction box and insert the two
self-threading screws with their washers
and screw them into the panel until tight
(see Figure 2.8).
to spring clamp
the panel
DS6100
Figure 2.7 - Scanner using junction box
with an
Figure 2.8 - Junction box mounting
Junction Box
Scanner cable
System cables
Installation - 2.9
DS6100