Water Fill Does Not Stop At Proper Level, Fill Error "Er", "Fl", Overflow Error "Er", "Of - ALLIANCE AWNE82SP113FW01 Troubleshooting Manual

Troubleshooting
10. Water Fill Does Not Stop At Proper Level, Fill Error "Er", "FL",
Overflow Error "Er", "OF"
Note: To test the pressure sensor
1. Ensure sensor is connected to the front end control and there is no damage to the harness.
2. Press the 4 and 14 key pads (refer to Figure 1) at the same time while water is filling. If no change is viewed
on the display, first check pressure hose for damage. If hose is ok, replace pressure sensor.
Water fill does not
stop at proper level.
Is there
"Er", a PS
Pressure Sensor
error?
No
Is there
an "Er", "OF"
overflow
error?
No
Is
there an
air leak in
pressure
hose?
No
Is mixing
valve
inoperative?
No
18
Test
Yes
pressure
sensor.
Yes
Replace
hose.
Test valve and
Yes
replace if
inoperative.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Was
there a siphoning
action started in washer
causing water to be
siphoned from washer
during cycle due to end
of drain hose being
lower than cabinet top of
washer?
Install 562P3
Siphon
Break Kit.
No
Provide an air
gap around drain
hose and drain
Does drain
receptacle.
Yes
hose fit tight
Install No. 36878
in standpipe
Standpipe Adapter
or drain?
(optional on some
models).
No
Is there Blow air through
Yes
water in hose to remove
pressure water or replace
hose.
hose?
No
Is there
broken,
Refer to
Yes
loose,
appropriate
shorted or
wiring diagram.
incorrect
wiring?
Yes
TLW425S
203562