Stiga TITAN 740 DC Instructions For Use Manual page 91

Hide thumbs Also See for TITAN 740 DC:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 78
6.13 AIR FILTER, ENGINE (5:H)
The engine must never be run when the
air filter is damaged or without an air
filter. Risk of serious engine damage.
The air filter consists of two filters as follows:
6:H2Pre-filter
6:H3Inner air filter
NOTE! Clean/replace the filters more often than
stated in the maintenance schedule if the machine
operates in dusty conditions.
Clean/replace the air filters as follows.
1. Open the filter housing by releasing the two
clamps (6:H1).
2. Remove the pre-filter (6:H2) and leave the in-
ner filter (6:H3) in place so that dust etc. does
not penetrate the engine when the pre-filter is
being blow cleaned.
3. Blow clean the pre-filter. Take care not to dam-
age the filter. Blow from the inside out using
compressed air. The pressure must be 3-5 bar.
If the pre-filter cannot be cleaned or if it is dam-
aged it must be replaced.
4. Clean the filter housing internally.
5. If the air filter must be replaced, pull this out as
well.
6. Reassemble all parts in the reverse order.
7. Reset the filter indicator if it has tripped. See 4.
ENGLISH
6.14 LUBRICATION
All lubrication points according to the table below
must be lubricated after every 50 operating hours
as well as after each clean.
Use a grease gun, filled with universal grease.
Pump until grease protrudes. The lubrication
points are shown in fig. 13-14.
Note the belts when lubricating. Belts
must not come into contact with oil or
grease.
Object
Tension arm,
pump belt
Lifting fork,
turning
Lifting fork, up-
down
Lifting cylinder 2 lubrication nipples
Control cylinder 2 lubrication nipples
Pivot point
Throttle cable
6.15 VALVES
Valve adjustment and grinding should be carried
out by authorised workshops.
Original instructions for use
Lubrication nipples /
action
1 lubrication nipple.
1 lubrication nipple
2 lubrication nipples
3 lubrication nipples
Lubricate the cable ends
using an oil can at the
same time as activating
the respective control.
Preferably carried out by
two people.
EN
Fig.
14:F
14:A
14:B
14:D
14:E
14:C
13
91

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Titan 740 dcr

Table of Contents