Table of Contents
Advertisement
WARNING! Make certain that the front frame is snapped
securely to both the right frame assembly and to the
left frame assembly.
INSTALL THE BATTERY WELL FRAME.
1. Hold the battery well frame so that the bottom of the well hangs
downward.
2. Position the notches on the front of the battery well frame onto the
locating pins on the front frame bottom bar. See figure 23.
3. Fit the notch on either side of the rear of the battery well frame onto
the locating pin on the power base frame assembly and onto the
locating pin on the other power base frame assembly.
4. Make certain that the locking mechanisms snap securely into place.
INSTALL THE BATTERY BOXES.
1. Place the front battery box into the front end of the battery well
frame.
NOTE: Make certain that the connectors are facing toward the
centre.
2. Place the rear battery box into the back end of the battery well
frame. Make certain that none of the wiring harnesses or cables
are pinched between the battery or the motor controller box and
the frame.
3. Connect the battery boxes. Use the battery connection label for a
reference.
4. Reconnect the left and right motor connectors. Be certain to match
the left connector to the left motor and the right connector to the
right motor. The connectors are labeled left and right.
INSTALL THE SEAT.
1. Lift the seat directly up and position it over the power base so that
the seat posts line up with the seat mount connectors.
2. Slide the seat posts down into the seat mount connectors.
3. Align the locating holes in the seat posts with those in the seat
mount connectors, and insert the T-handle ball detent pins through
the holes.
INSTALL THE SWING-AWAY LEG RESTS.
1. Press and hold the locking lever, and slide the swing-away leg rest
into the mounting bracket.
2. Swing the leg rest to the centre position.
3. Release the locking lever to lock the leg rest in place.
4. Repeat steps 1 through 3 for the opposite leg rest.
CONNECT THE JOYSTICK/CONTROLLER.
1. Reconnect the joystick/controller harness to its connector on the
electronics tray. See figure 6.
WARNING! Do not place the joystick/controller harness
so that it can be pinched in the seat frame or the power
base frame.
Quantum Dynamo ATS RevB/Jun04
Figure 21. Connecting Front Frame Assembly
Figure 22. Fitting the Frames
Figure 23. Connect Battery Well Frame
www.pridemobility.com
ASSEMBLY
LOCATING
PINS
27
Advertisement
Table of Contents
