Pride Dynamo ATS Owner's Manual page 25

BATTERY WELL FRAME
RIGHT POWER BASE
FRAME ASSEMBLY
Figure 14. Quantum Dynamo ATS Component Assemblies
DISCONNECT THE JOYSTICK/CONTROLLER HARNESS.
Disconnect the joystick/controller harness from its connector on the
electronics tray. See figure 6. You may need to pull firmly and gently
wiggle the harness to remove it from the connector.
REMOVE THE SEAT.
WARNING! Depending on the size of the seat, Pride rec-
ommends that two people remove the seat to avoid pos-
sible damage to the seat or your Quantum Dynamo ATS.
1. Remove the four (4) T-handle ball detent pins securing the seat to
the power base.
2. Allow the seat to rest on the seat mount connectors.
3. Lift the seat directly up. See figure 15. You may find it necessary to
rock the seat gently from side to side to free the seat posts from the
seat mount connectors.
WARNING! Do not pick up the seat frame by the
armrests. They may be free to pivot, and you may lose
control of the seat if they do so, resulting in personal
injury or damage to the chair.
REMOVE THE SWING-AWAY LEG RESTS.
1. Press and hold the locking lever to unlock the leg rest. See figure 16.
2. Swing the leg rest to the side, then lift it straight up to remove it
from the mounting bracket.
Quantum Dynamo ATS RevB/Jun04
FRONT FRAME
www.pridemobility.com
Figure 15. Removing the Versa Seat
LOCKING LEVER
Figure 16. Removing the Swing-away Leg Rest
DISASSEMBLY
BATTERY BOXES
LEFT POWER
BASE FRAME
ASSEMBLY
SEAT POST
SEAT MOUNT
CONNECTOR
25