Table of Contents
Advertisement
WEEKLY CHECKS
n
Disconnect and inspect the joystick/controller harness from the electronics tray. Look for corrosion. Contact your authorised
Pride Dealer if necessary.
n
Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.
n
Check for proper tyre inflation; there should be 2.4 bar (35 psi) in each tyre. If a tyre will not hold air, replace the tube.
n
Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate properly.
n
Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your
power chair.
To calibrate the joystick:
1. Position the joystick in the full reverse position and hold it there. Turn on the controller.
2. The battery condition metre lights up from one light to ten lights, and then back to one light. It does this twice, then
blinks rapidly.
3. Turn off the controller.
4. Position the joystick in the full forward position and hold it there; then turn the controller on.
5. The battery condition metre lights up from one light to ten lights, and then back to one light. It does this twice, then
blinks once, and then it blinks continuously.
6. Turn off the controller. Now the joystick and controller are set up to function properly together.
To check the brakes:
1. Turn on the controller and set the speed adjustment to the slowest setting.
2. After one second, check the battery condition metre. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click.
NOTE: Your power chair may move when performing this test. Immediately release the joystick. You must be
able to hear each electrical brake operating within a few seconds of joystick movement.
MONTHLY CHECKS
n
Check that the anti-tip wheels do not rub the ground when you are operating your power chair; adjust them as necessary.
n
Check for extreme wear on the anti-tip wheels. Replace them as necessary.
n
Check for drive tyre wear. See an authorised Pride Dealer for repair.
n
Check the rear casters for wear. Replace as necessary.
n
Check the rear forks for damage or fluttering which indicates that they may need to be adjusted or the bearings may need
to be replaced. See an authorised Pride Dealer for repair.
n
Keep your power chair clean and free of foreign material such as hair, food, drink, etc.
YEARLY CHECKS
Take your power chair to an authorised Pride Dealer for yearly maintenance. This helps to ensure that your power chair is
functioning properly and helps prevent future complications.
STORAGE
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries.
See "Batteries and Charging."
WARNING! If you fail to store the unit under the above conditions, the frame can rust and the electronics can be
damaged.
CLEANING INSTRUCTIONS
WARNING! Never hose off your Jet or place it in direct contact with water. Your power chair has a painted, ABS
plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or
dry out and crack. Use soapy water and dry the seat thoroughly.
Quantum Dynamo ATS RevB/Jun04
www.pridemobility.com
CARE AND MAINTENANCE
29
Advertisement
Table of Contents
