Positioning Belt - Pride Dynamo ATS Owner's Manual

POSITIONING BELT

Required Tools/Materials:
n
5/16-in. x 2-in. button head socket cap screw
n
5/16-in. washer
n
5/16-in. spacer
n
Black plastic spacer
n
5/16-in. Nylock nut
n
3/16-in. hex key
n
1/2-in. open-end spanner
An auto-type positioning belt is available for your power chair as an optional accessory. The positioning belt is designed to
support the operator so that he/she does not slide down or forward in the seat and can be adjusted for operator comfort. The
positioning belt is not designed for use as a restraining device. See figure 11.
To install the positioning belt (if required):
1. Insert the 5/16-in. x 2-in. button head socket cap screw through the 5/16-in. washer and the mounting tab at the end of the
positioning belt.
2. Install the screw through the 5/16-in. spacer and the large black plastic spacer, then insert the screw through the seat base
rail at the rear of the seat.
3. Install the 5/16-in. Nylock nut to the assembly, and then tighten the screw and nut using a 3/16-in. hex key and a 1/2-in
open-end spanner.
4. Repeat steps 1-3 for the other side.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you hear
a click.
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
Figure 11. Positioning Belt Installation and Adjustment (Export Seat)
Quantum Dynamo ATS RevB/Jun04
BLACK
PLASTIC
SPACER
NUT
SPACER
WASHER
SCREW
www.pridemobility.com
COMFORT ADJUSTMENTS
PULL TO
TIGHTEN
17