Advertisement
Advertisement
Related Manuals for Pride I-Go 5513
Summary of Contents for Pride I-Go 5513
- Page 1 Castricummer Werf 26 1901 RW Castricum The Netherlands...
-
Page 2: Table Of Contents
CONTENTS I. INTRODUCTION CONTENTS---------------------------------------------------------------------1 Read and follow all instructions, warnings, and notes in this manual before attempting to operate your power wheelchair for the first time. If INTRODUCTION---------------------------------------------------------2 there is any information in this manual which you do not understand, or if you require additional assistance for assembly or operation, please ATTENTION---------------------------------------------------------------3-4 contact with your authorized local provider. -
Page 3: Attention
II. ATTENTION II. ATTENTION Please note: 2.2.6 Please ensure that the controller system fixed well, joystick is This power chair is an electrical, non-aseptic, reusable product without straight and correct. Sit comfortably and fasten the lap belt. Sit back chemical substances against the backrest, this helps with stability on oneven roads. -
Page 4: Structure And Performance
III.STRUCTURE AND PERFORMANCE III.STRUCTURE AND PERFORMANCE 3.STRUCTURE AND PERFORMANCE 3.1 Power chair consists of several parts mainly(figure 1): Chair-Frame: It consists of a foldable component, which can be folded from the seatbase’s middle in order to store or transport conveniently. 3.2 Product characteristics of the electric wheelchair Joystick: It has the function of moving forward, back, turning, speed Classification according to prevent electric shock type : internal power... -
Page 5: Assemnly/Folding/Debug
III.STRUCTURE AND PERFORMANCE IV.ASSEMNLY/FOLDING/DEBUG 5.1 Installation 5.1.1 Take out the wheelchair from the packing box and put it on the ground. Push the backrest and footrest back and forth respectively SPECIFICATION by two hands(figure 2). When you hear a click, the locating pins are inserted into the positioning holes, and in this case, the chair frame Overall Dimensions 900mmX600mmX880mm... - Page 6 IV.ASSEMBLY/FOLDING/DEBUG IV.ASSEMBLY/FOLDING/DEBUG CAUTION! 1. Make sure that the locating pins have been inserted into the positioning holes when the wheelchair has been fully folded open, and then it can be used. 2. Make sure that the anti-tippers are fully pulled out in order to prevent the wheelchair back from tipping over, which may result inpersonal injury.
-
Page 7: Operation
V. OPERATION V. OPERATION battery gauge on/off button 6. USE, OPERATION chearger socket horn button 6.1 Use speed light speed down button 6.1.1 Controller: It is the key component of a wheelchair. All electronics speed up button to operate the latter are housed in it(figure 18). Usually the controller is joystick installed in one armrest, which is connected with motor and battery on power box. - Page 8 V. OPERATION V. OPERATION 6.1.4Circuit breaker forward The circuit breaker, which is located in the battery box, is set for the wheelchair’s safety. Once motors or batteries overloaded, the circuit right left breaker will trip to cut off the power. After one or two minutes, it will automatically reset and then you can continue to drive the wheelchair.
-
Page 9: Maintenance
VI. MAINTENANCE VI. MAINTENANCE 9. Maintenance WARNING! 9.1 Maintenance Never let the battery freeze, do not charge the frozen battery, Your power wheelchair also requires routine maintenance like other which may cause personal injury and the battery damaged. motorized vehicles. Some checks can be performed by yourself, but others require assistance from your service agent. -
Page 10: Warranty
VII. WARRANTY 10.2 Storage Your wheelchair should be stored in a dry condition free from sources of extreme temperature and dampness. Remove the batteries from the wheelchair prior to storage. Otherwise, the frame may be rusted and the electronics may be damaged. 11.
Need help?
Do you have a question about the I-Go 5513 and is the answer not in the manual?
Questions and answers