Disassembly - Pride Dynamo ATS Owner's Manual

DISASSEMBLY

We work closely with our battery manufacturer to provide a battery that best suits the Quantum Dynamo ATS's specific
demands. Fresh batteries arrive regularly and are promptly shipped with a full charge. During shipping, the batteries encoun-
ter temperature extremes that may influence their initial performance. Heat robs the charge from the battery, and cold slows
the power available and extends the time needed to recharge the battery (just as with a car battery).
It might take a few days for the temperature of the battery to stabilise and adjust to its new ambient temperature. More
importantly, it takes a few "charging cycles" (a partial drain, then a full recharge) to establish the critical chemical balance that
is essential to the battery's peak performance and long life. It is well worth it for you to take the time to break in the batteries
properly.
NOTE: The useful life of a battery is quite often a reflection of the care it receives.
HOW CAN I ENSURE MAXIMUM BATTERY LIFE?
A fully charged deep-cycle battery provides reliable performance and extended battery life. Keep the batteries fully charged
whenever possible. Batteries that are regularly and deeply discharged, infrequently charged, or stored without a full charge
may be permanently damaged, causing unreliable power chair operation and limited battery life.
HOW SHOULD I STORE MY QUANTUM DYNAMO ATS AND BATTERIES?
If you do not use your power chair regularly, we recommend maintaining battery vitality by charging the batteries at least once
a week.
If you do not plan on using your power chair for an extended period, fully charge the batteries prior to storage. Disconnect the
battery harnesses and store your power chair in a warm, dry environment. Avoid temperature extremes such as freezing
conditions and excessively hot conditions, and never attempt to charge a frozen battery. A cold or frozen battery should be
warmed for several days prior to recharging.
NOTE: If you are storing your power chair for an extended period of time, you may wish to block the unit up off
of the ground with several boards under the frame. This keeps the tyres off of the ground and prevents the
possibility of flat spots developing on the tread area of the tyres.
WHAT ABOUT PUBLIC TRANSPORTATION?
AGM and Gel-Cell batteries are designed for application in power chairs and other mobility vehicles, allowing safe transpor-
tation on aircraft, buses, and trains, as there is no danger of spillage or leakage. We suggest you contact the carrier's ticket
counter in advance to determine that carrier's specific requirements.
WHAT ABOUT SHIPPING?
If you wish to use a freight company to ship your power chair to your final destination, repack it in the original shipping
container and ship the batteries in separate boxes.
D
ISASSEMBLY
Your Quantum Dynamo ATS disassembles into eight easily transportable component assemblies (seat and leg rests not
shown)—with no tools required. See figure 14.
WARNING! Even though no tools are required to disassemble or assemble your Quantum Dynamo ATS, you
should not place your hands or fingers on the areas of the component assemblies where they may be pinched,
as the assemblies "snap" together or "snap" apart.
NOTE: During both disassembly and assembly of your Quantum Dynamo ATS, take your power chair out of
freewheel mode so that the chair does not roll while you are disassembling or assembling it. See “Your Quan-
tum Dynamo ATS.”
DISASSEMBLY PREPARATION
Position your power chair in a location where there is ample working room on all four sides. We recommend three or more feet
of clearance on all sides. There are eight component assemblies, some of which take up a great deal of space when
disassembled from the chair. Make certain that your power chair is powered off.
24 www.pridemobility.com Quantum Dynamo ATS RevB/Jun04